37 Beneteau 2017 Boat for Sale

INTERIOR 

• Woodwork Alpi Mahogany
• Parquet type laminated floors
• Hull spar ceilings in cabins + in the salon

COMPANIONWAY 

• Headroom: 1.93 m  
• Companionway and steps in polyester  
• 2 Stainless steel guardrails   
• 1 Fixed zenital window with curtain

FORWARD CABIN 

• Headroom: 1.91 m  
• Central double bed (2.10 m x 0.42 m x 1.87 m), Marine mattress  
• Hanging locker - shelves - Cubby hole lockers - Storage - Dressing table  
• 1 Removable seat  
• 1 Opening hatch with curtain

SALOON

• Headroom 1.92 m  
• U shaped saloon bench to port, double density foam
• 1 Starboard bench seat
• 4 Matching decorative cushions
• Saloon table with wooden mounting
• Cubby hole lockers - Storage space along the hull - Bar storage space - Storage under bench seats
• 1 Port side window with curtain
• 1 Starboard side window with curtain
• 2 opening porthole in side window - To port
• 1 opening porthole in side window - To starboard
• 2 Hull portholes with curtain
• 1 Opening deck hatch with curtain

GALLEY

• L-shaped kitchen 
• White laminated worktop 
• 2 Rectangular stainless steel sinks 
• 1 Mixer tap cold water / hot under pressure 
• 1 2 hob gas cooker on mounting - 1 safety bar 
• 1 Refrigerator 110 litre front opening - Refrigeration unit 12 V 
• 1 Dresser with drain system - Closure / Cutting board 
• Cupboard - Fitted storage space and lockers 
• 1 Rubbish bin 
• 1 Porthole opening onto combing in side window

ELECTRICAL

• 12V circuit
• 2 service batteries 110 Amperes (Port aft cabin)
• 1 Battery for engine 70 Amperes (Port aft cabin)
• 1 Charge divider
• Electrical panel 12 V (Fuses - Voltmeter - 1 Water gauge - 1 Fuel gauge - 1 Low battery charge warning - 1 Low diesel and water tank warning)
• 1 Socket(s)12 V
• Lighting: 1 Fluorescent lamp White, Halogen ceiling lights, 1 White/red light fitting
• Navigation lights: 1 navigation light(s)fore and aft - 1 Engine navigation light / Crosstree light forward of mast - 1 Mooring light on masthead
• Wire runs for options cables

ENGINE

• Yanmar Diesel 29 hp (approximately 359 hours)
• Primary fuel filter upgraded to Racor 30 micron filter
• Engine control - fitted in cockpit
• Engine compartment: Soundproofing foam - Ventilation: 1 air intake and 1 pressured air outlet
• 1 ALTERNATOR 12 V / 80 Ah
• 1 Rotation moulded diesel tank 130 L (under starboard aft berth) - Electronic gauge - Low level alarm - 1 Deck filler
• Filters: Sea water - Diesel - Decanter
• Stainless steel shaft line - Polyester guard moulded into hull
• 3 blade Flexifold prop
• 1 Engine access through companionway (opening with 2 gas pistons)
• 2 Engine access through aft cabins (3 cabin version) or in the washroom and the aft cabin (2 cabin version)

DESIGN & CONSTRUCTION

• Design made following European Directive requirements and according to EC certification
• Monolithic hull design in polyester
• Monolithic structural counter moulding laminated and stuck to hull
• Deck in balsa and glass fibre sandwich covered in «diamond point» type non-slip surface
• Deck hull join screwed, stuck and banded with 1 soild wood bulwark, screwed
• Cast iron keel fixed with bolts and stainless steel veneer and stuck
• Hung rudder with stainless steel stock
• White coloured hull - Hull decorated in pearl grey

RIGGING

• Furling in mast 9/10 electro-polished aluminum installed on the deck, 2 level(s) of advanced cross trees
• Anodized aluminum boom
• Discontinuous stainless steel standing rigging (Forestay, Shrouds, Lower shroud, Backstay)
• 2 Backstays with turnbuckles
• 1 Forestay Classical
• 1 Rigid boom down-haul with tackle
• 1 Genoa furling system with drum on the deck
• 1 Mainsail sheet track
• 2 genoa sheet tracks with piston adjusted traveller cars - 2 Genoa sheet return blocks
• Rigging run back to cockpit (except boom topping lift - Foot tuning line)
• Complete running rigging: 1 Main halyard - 1 genoa halyard with clutch on mast and cleat - Boom topping lift with cleat on mast - 1 Mainsail foot - 1 Main sheet on traveller - 2 Genoa sheets - 2 fast reefing ropes
• 5 clutches to port
• 3 jamming cleats

WINCHES

• 2 Self-tailing genoa sheet winches (H46.2 STC)
• 2 Rigging winch self tailing on deck house (H35.2 STC)
• 2 Aluminium winch handles
• 2 Winch handle boxes

SAILS

• 1 Furling genoa with UV protective strip
• Roller furling main

MOORING -ANCHORING

• Self-bailing chain locker - Clench bolt - Hatch cover
• 1 Stainless steel bow fitting - 1 Stem roller
• mechanically welded stainless steel roller
• 6 Aluminum mooring cleats - Stainless steel deck line protection