In Do Time Yacht for Sale | 42 Krogen Yachts Myrtle Beach, SC

Cruising Speed: 7 kn
Maximum Speed: 8.5 kn
Beam: 15' 0''
Hull Material: Fiberglass
Fuel Tank: 1 x 700|gallon
Fresh Water: 1 x 360|gallon
Holding: 1 x 40|gallon
Heads: 2

Lets start forward, she has a teak pulpit with windlass. Forward on the cabin is built-in seating. She has walkways both port and starboard leading to the aft deck that is wrapped with teak. The aft deck has a transom door to her swim platform and ladder to the bridge deck. Her bridge has a nice helm forward, solar panels over her pilot house top, and a large deck (which has been re-cored and glassed) and dinghy storage.

Entering her cabin from the aft deck, she has seating to starboard and a couch to port. Moving forward she has a bookcase built-in over her power panel to port and galley to starboard. Just to the port side of centerline she has the companionway forward. Her guest stateroom is to starboard and features a single berth on the starboard outer bulkhead and Pullman berth forward. Across form the guest stateroom is the guest head on port. Again moving forward is her master stateroom with a full berth to starboard (storage below) and storage on port. Her master head is in the forepeak.

Access to her engine room is forward in the salon and centerline below the salon floor.

Garmin GHC 20 Autopilot Control (also controlled by Chart Plotter & I-Pad)
Garmin 7607xsv Chart Plotter/GPS/Sounder
(2) Ritchie Compasses (lower & upper)
Garmin GMR 18HD Radar
(2) Standard Horizon Eclipse VHF Radios (lower & upper)
Standard Horizon handheld VHF Radio
Samsung Television
Blackweb Video Camera Display (engine room)
Garmin handheld Autopilot Remote
Mini I-Pad (connects to Garmin)

"Mr. Coffee" Coffee Maker
U-Line Ice Maker
Isotherm Refrigerator
Double Stainless Steel Sink
Princess 3-burner Propane Stove with Oven
Raritan 20-gallon Water Heater
Cold & hot, pressure, dockside Fresh Water System
Interior Teak refinished
Parquet Sole in Salon and Lower Deck
Teak Sole in Pilothouse
Surflo Aqua King II 4gpm freshwater pump
(2) Jabsco Electric Heads
Jabsco Macerator Pump
Custom back splash in galley
Carbon Monoxide Detectors
Smoke Alarms
Proctor Silex Toaster

110V / 30AMP AC Electrical System
Battery Parallel Switch
ProMariner ProNautic 1250 50-AMP Automatic Battery Charger
12V DC Electrical System
Phasor 8 kw Generator (NEW 3/2025)
Xantex 3-KW Inverter/Charger
Interior Lighting has LED bulbs
Full Vessel re-wired including panels (2017)
(3) Solar Panels (450W)
Victron Solar Controller
(4) LifePro 600 amp Hour 31 Series Batteries (2025-House)
Intimidator AGM-8D (2020-House)
(2) AGM 8D (2021-Cranking)
AGM Genset (2022)
8D Battery (2021-Thruster & Windlass)

Rocna Anchor 33kg with 150' Chain & 150 3/4 Rode
Plow Anchor with 25' chain and 150 Rode
Teak Bow Pulpit with dual rottery
LED Spreader Lights
Bimini Top
Transom Freshwater Deck Wash Down System
ACR Electric Remote Controlled Search Light
Swim Platform
Swim Ladder
Lewmar Electric Windlass
(3) Windshield Wipers
Exterior Awlgrip rolled & tipped (2020)
Decks Refinished with Pettit Toughcoat(2020)
Bridge Deck re-cored & Glassed (2017)
Stainless Steele Bow Rail
(2) Mast & Boom with Endurance Winches (2022)
2015 Highfield Aruba C9 Dingy (9', purchased new in 2020)
2022 Yamaha F6SMHA Outboard (6hp, 4-Stroke)
Bottom Paint (3/2025)

Engine has had a full Overhaul in February, 2023.
Dometic 32,000 Reverse Cycle Air Conditioner (2-units, 2017)
(2) Bilge Blowers
(3) Rule 2000 Bilge Pumps
Wesmar 12-volt Bow Thruster
Dickson Hydraulic Stern Thruster
Cabin & Bridge Engine Controls
Reverso Oil Change System
Johnson High water alarm
Fresh Water Cooling System
Racor Fuel Filters
Hydraulic Steering
Engine Crash Pump
Morse Controls
Tides dripless Stuffing Box
SEAFLO Dry Bilge System
Nibral 3-blade Propeller
Borg-Warner Velvet Drive Transmission (model 10-18-012, rebuilt 2025 with 20 hours)
Jabsco Fuel Transfer Pump
Fiberglass Fuel Tanks
Fuel Burn: 1800rpms at 7-7.5knots burning 1.7 gph, with 700 gallons of fuel she has a 2000 mile range
Ford Lehman 120 hp with 800 hours on full Rebuild (2023)
Cutlass Bearing (3/2025)